---

SPARCserver 1000E

501-2668
0MB FRU w/o SPARC Module

Jumper Settings

JUMPER PINS SETTING DESCRIPTION J1200 J1201 J1200 J1201 1-2 1-2 2-3 2-3 Out Out In In RS-423 RS-423 RS-232 +12V (default) RS-232 -12V (default)

Configured System Boards

PART#	MEMORY	SIMM	MODULE
501-2764	64MB	8MB	1 SM61
501-2765	128MB	32MB	2 SM61
501-2766	0MB	-	2 SM61
501-2998	0MB	-	2 SM81
501-3038	128MB	8MB	2 SM81
501-3039	256MB	32MB	2 SM81

Notes

1. The minimum operating system is Solaris 2.3.
2. The SM81 requires Solaris 2.4 and Patch >=101945-35.
3. Install the highest level Boot PROM set in System Board 0.
4. Boot PROMs >=2.18 disable 40MHz System Boards if they are installed in systems using the 50MHz Control Board.
5. Use SPARC module and SBus board Standoff 330-1664-01.
6. A root partition >2GB is not supported by Sun-4c, 4m, or 4d systems.

Memory Configuration Notes

1. The minimum memory configuration is 4 SIMMs in Group 0.
2. Use 8MB SIMMs 501-1817 and 32MB SIMM 501-2196.
3. Install all Group 0 SIMMs on all system boards from the lowest board slot number to the highest. Then install SIMMs in Group 1 on all system boards, followed by Group 2 and Group 3. Refer to the Memory Module Installation Guide for installation performance guidelines.

References

1. SPARCserver 1000 Installation Manual, 801-2893.
2. SPARCserver 1000 System Board Manual, 801-2900.
3. Memory Module Product Note, 801-5345.
4. Memory Module Installation Guide, 801-2030.
5. BugID 4035259 filed against root partition >2GB.

Notes

1. The 50MHz Control Board is not compatible with the SS1000 System Board and SuperSPARC modules that run at 40MHz on the XDBus.
2. Boot PROMs >=2.18 disable 40MHz System Boards if they are installed in systems using the 50MHz Control Board.
3. The HOSTID and Ethernet Address are programmed into a 2KB x 8-bit Flash EEPROM in the TMS29F816 at U0201. The TMS29F816 is not field replaceable.
4. The HOSTID and Ethernet Address are downloaded from the control board to the NVRAM on all system boards during POST.
5. If the control board EEPROM content is invalid, the values stored in the NVRAM on System Board 0 are used.
6. The Yellow LED on the keyswitch interface board is ON if the control board EEPROM content is invalid.
7. Use the update-system-idprom OBP command to download the contents of the NVRAM on System Board 0 to a control board with an invalid EEPROM. OBP 2.11 is required.
8. Use the following command sequence to invalidate the control board EEPROM:
   

   ok patch noop call update-system-idprom

   ok patch noop call update-system-idprom

   ok patch call noop update-system-idprom

   Power the system off and remove the Control Board.
   
9. Use the following commands to change the NVRAM parameter that defines the location of the master system board:
   

   ok clear-master-nvram

   ok reset