Seagate 97229-11G (911MB)

Equipment Number PA8Y2

8" 3600 RPM IPI-2 6MB/Sec

Options 716 / 717 / 719 / 720 / 741L / 742L / 743L / 744L / 745L

Operator Panel
370-1355

Note

Each drive power-on sequence is delayed for a time equal to five seconds times its address. For example, if the address is 3, the drive starts after a 15-second delay.

Disk Enclosure

Control Board Dip Switch Settings

Dip Switch 1, Switches 5 and 6

SWITCH	DESCRIPTION
5	Not used
6	Open = Write protected Closed = Write enabled

I/O Board Rear View

Power Connector

15	14	13	12	11	10	9	8	7	6	5	4	3	2	1
+24 RTN	+24	+24	+24	+24 RTN	+24 RTN	N/C	PWR OK	-12	-5	-5	GND	GND	+5	+5

Dip Switch 1 Settings

SWITCH	SETTING	DESCRIPTION
1 2 3 4	Open Closed Open Closed	Drive starts when DC Power is applied Disable Port B Enable Port A Disable internal diagnostics
5 6 7 8	Open Closed Open Closed	1D 3 1D 2 1D 1 1D 0	ID Microcode. Do Not Change " " "
9	Open	Slave/Master spindle sync-slave

Notes

1. The 911MB Disk requires minimum ISP-80 firmware 525-1023-05, 525-1024-07, and 525-1025-07.
2. ISP-80 501-1539-05 and 501-1855-01 contain the minimum firmware required by the 911MB Disk.
3. Upgrade lower revision ISP-80 Controller boards with Option X2080A.
4. Use terminator 370-1220-01 on the Port A/B Out connector.
5. Disable an unused port with the Port Enable/Disable switch.
6. Do not install a terminator on an unused port.
7. There are cooling vents on the cover of 911MB Drive 370-1351. Do not install this drive in the Sun Expansion Pedestal.
8. There are no cooling vents on the cover of 911MB Drive 370-1352. Do not install this drive in the Sun 56" Rack.
9. Power Supply 300-1052 does not support the 911MB Drive.
10. Use Power Supply 300-1075 in the Sun Expansion Pedestal.

References

1. IPI8-1000/2HP Disk Drive Configuration and Installation Procedures for the Sun Expansion Pedestal, 813-5377-11.
2. PI8-1000 and IPI8-1000/2HP Disk Drive Configuration and Installation Procedures for the Sun 56-inch Cabinets, 813-1109-10.