| Processor |
| Number |
4, 8, or 12 |
| Architecture |
UltraSPARC[tm] III Cu: 900MHz or 1200MHz
UltraSPARC IV (SF V1280 only): 1050MHz, 1200MHz or 1350MHz
UltraSPARC IV+ (SF V1280 only): 1.5GHz
|
| Cache per processor |
Primary (L1): Parity protected 32
KB instruction and 64 KB data on chip (single-bit errors are corrected)
Secondary (L2): 8 MB external cache
Level 3 cache per UltraSPARC IV+ processor: 32 MB shared external.
|
| System Interconnect |
9.6 GB/s Sun Fireplane interconnect.
System bus with redundant data, address and response crossbar interconnect |
| System
Boards |
| Number of boards |
Maximum of 3 CPU/Memory boards |
| CPU/Memory board |
Four processors each and up to 32 GB memory
per board; maximum 12 processors per server |
| Main Memory |
| 8 GB to 192 GB (Using 2 GB DIMMS) |
| Standard
Interfaces |
| Alarm |
One alarm port (DB15) |
| Ethernet |
- One ethernet/fast ethernet (10BASE-T/100BASE-T) twisted-pair port
(RJ-45)
(Used for LOM/System Controller)
- Two 10/100/1000BASE-T Ethernet (copper) ports
|
| PCI |
Six open 7 in., 64 bit PCI slots:
|
| Serial |
- One RS-232/RS-423 asynchronous/synchronous serial port (RJ45), Serial
A
- Serial B is reserved.
|
| SCSI |
One Ultra3 SCSI 68-pin SCSI port
- Single-ended (40MB/sec) or
- LVD (160MB/sec)
|
| Internal
Mass Storage |
| Disks |
Two 36GB SCSI internal disks, 1.0 in., 10,000 RPM
Sun Fire V1280 only:
Two 73GB SCSI internal disks, 1.0 in., 10,000 RPM |
| DVD-ROM |
DVD-ROM internal drive |
| Tape |
DDS-4 or DAT72 tape drive (optional) |
| Power
Supplies |
| Four power supplies providing 2N hot-pluggable
redundancy; only two are required for the system to run. |
| Environment |
AC input
(Sun Fire V1280) |
200-240V single phase AC, 47-63Hz, with two 11/13 Amp circuits
redundant with another two on a separate grid |
DC input
(Netra 1280) |
-48VDC or -60VDC |
| Input power |
3300W maximum |
| Heat output |
Base Configuration: 4,780 BTU/hr
Maximum Configuration: 11,300 BTU/hr
|
| Temperature |
Optimal: 22° C (72° F)
Range: 5° C to 40° C (41° F to 104° F)
|
| Humidity |
Optimal: 45% non-condensing
Range: 10% to 90% non-condensing humidity |
| Altitude |
Up to 3,048 meters (10,000 ft) |
| Acoustic noise |
73 dB(A) |
Regulations
Meets or exceeds the following requirements: |
| Safety |
North America: UL 60950 3rd edition,
CSA C22.2 No 60950-00 3rd edition (Certified: UL and UL for Canada)
European Community: EN 60950:2000, (Certified: UL for Germany/GS-Mark
and GOST R for Russia)
Worldwide except North America: IEC 60950:1999 and CB Bulletin (Certified:
DEMKO + UL for Argentina/IRAM S-Mark) |
| RFI/EMI |
Class A: Australia/New Zealand AS/NZ 3548,
Industry Canada ICES-003, European Community EN55022/CISPR22, Japan VCCI,
Taiwan CNS 13438, and US FCC 47CFR15.B. |
| Immunity |
EN55024, i.e. EN61000-4-2, EN61000-4-3,
EN61000-4-4, EN61000-4-5, EN61000-4-6, EN61000-4-8, and EN61000-4-11 |
| Dimensions and Weights |
| Height |
Chassis Only: 20.75 in (527 mm) / 12U
With Cradle: 21 in (533.4 mm) |
| Width |
Chassis Only: 16.75 in (425.6 mm)
With Baseline Skirt: 17.38 in (441.4 mm)
With Slides: 17.5 in (445 mm)
|
| Depth |
Chassis Only: 22 in (558 mm)
With Slides: 22.36 in (568 mm)
|
| Weight |
Chassis Only: 235.89 lbs (107 kg)
With Cradle: 286.60 lbs (130 kg) |
| Clearance and Service Access |
| Front |
35 in (88.9 cm) |
| Rear |
35 in (88.9 cm) |
Refer to the Sun Fire
V1280 / Netra 1280 Site Planning Guide
( 817-3334) for clearance and service access details. |
| Racking |
| All Sun racks and most third party; 24 in.
(600mm) and deeper racks; 2 per 4 post rack, 1 per 2 post rack |
