| Processor |
| Number |
two to four |
| Architecture |
1.593 GHz UltraSPARC IIIi |
| Cache memory |
1 MB Level 2 |
|
Main Memory |
| Capacities |
4 DIMM slots per processor.
Support for 512MB, 1 GB and 2 GB DIMMS.
DDR1 PC2700 DIMMs.
Minimum configuration: 4GB (two CPU/memory modules with four 512-MB DIMMs).
Maximum configuration: 32GB (four CPU/memory modules fully populated with 2-GB DIMMs).
|
|
Standard Interfaces |
| Ethernet |
4 RJ-45 on board 10/100/1000BASE-T Gigabit/Fast Ethernet ports
|
| PCI |
8 PCI slots (4 PCI-E slots/4 PCI-X slots)
NOTE: One of the short PCI-X slots may be occupied by a disk drive controller.
New standard configurations with an integrated controller installed into the disk backplane are available, thereby making the previously occupied short PCI-X slot available. All systems that initially shipped with the PCI-X based disk controller can be upgraded in the field by ordering the FRU part F501-7244 - PCIe SAS-SATA Controller Board.
The use of this controller will require the redefinition of the boot path as it is PCIe based, not PCI-X. It is encouraged that Services be contacted for the installation.
|
| System Management |
One Serial Management RJ45 port.
One Network Management 10Base-T Ethernet, RJ45 port.
Support for: Sun Management Center, Sun SNMP Management Agent,
Advanced Lights Out Management (ALOM), Sun Net Connect, and Sun Update Connection.
|
| Serial |
2 Serial Ports
1 DB-9 connector and 1 RJ45 connector
The RJ45 port is used for serial management.
|
| USB |
Four USB 2.0 compliant ports, two front and two rear. |
| SCSI |
None |
|
Internal Mass Storage |
| Disks |
Up to 8 73GB or 146GB, 10,000rpm, 2.5" SAS disk drives.
Hardware RAID 0 and 1.
Drives are front-accessible, hot-pluggable.
|
| DVD-ROM |
One internal combination CD/DVD-RW writer. |
|
Environment |
AC Power Consumption
Typical Operating Range |
327 - 557 W for operation @ 100 VAC to 240 VAC. |
| Maximum AC Input per Power Supply |
660 W. |
| Maximum DC Output per Power Supply |
550 W. |
| AC Power Consumption |
Typical Operating Range: 327 - 557 W for operation @ 100 VAC to 240 VAC. |
| Heat Dissipation |
Typical Operating Range: 1065-2689 BTU/hr. for operation @ 100 VAC to 240 VAC
Maximum Heat: 3157 BTU/hr. for operation @ 100 VAC to 240 VAC.
|
| Temperature |
Operating: 5°C to 35°C (41°F to 95°) non-condensing.
Nonoperating: -40°C to 35°C (-40°F to 95°) non-condensing.
Minimum temperature of -20°C is required if NiMH batteries are used.
|
Humidity
(IEC 60068-2-3&56 ) |
Operating: 20% to 80% relative humidity, noncondensing, 27°C
max wet bulb
Nonoperating: Up to 93% relative humidity, noncondensing, 38°C
max wet bulb |
Altitude
(IEC 60068-2-13) |
Operating:0 to 3,000m (0 to 10,000 ft.);
Max. ambient temperature is derated by 1° C per 500 m. above 500 m.
Nonoperating: 0-12,000 m (0 to 40,000 ft.)
|
Acoustics
ISO 9295/9296
(ISO 7779:1988) |
Operating: At full speed 75 dBA
Nonoperating: N/A
Declared acoustics is as declared in Bels, per ISO 9295/9296 because acoustics is the only test where there are no formal input-response scenarios that lead to pass-fail criteria. |
Vibration
(IEC-60068-2-6&64) |
Operating: 0.0001 g2/Hz, 5 to 150 Hz, -12db
/octave slope 150 to 500 Hz.
Nonoperating: 0.001 g2/Hz, 5 to 150 Hz, -12db
/octave slope 150 to 500 Hz.
|
| Shock |
Operating: 3.0 g peak, 11 milliseconds half-sine pulse
—IEC 60068-2-27.
Nonoperating: 15.0 g peak, 11 milliseconds half-sine pulse; 1.0
roll-off front to back, 0.5 inch roll-off side to side.
|
Handling Drops
(IEC 60068-2-31) |
60 mm, 1 drop per corner, 4 corners.
|
Threshold Impact
(ETE 1010-01) |
0.85m/s, 3 impacts per caster, all 4 casters, 25 mm step-up. |
Regulations
Meets or exceeds the following requirements:
|
| RoHS Compliance Level |
RoHS:YL |
| Safety |
UL 60950, CB Scheme IEC 950, CSA C22.2 950 from UL
TUV EN 60950
UL CB scheme IEC 950 (CE mark)
|
| RFI/EMI |
47 CFR 15B Class A
EN55022 Class A
VCCI Class B
AS/NZ 3548
CNS 13438
KSC 5858
ICES-003
|
| Immunity |
IEC 1000
EN55024 per EMC Directive 89/336/EEC, including
IEC 61000-4-2 Electrostatic discharge immunity test
IEC 61000-4-3 Radiated, radio-frequency, electromagnetic field immunity
test
IEC 61000-4-4 Electrical fast transient/burst immunity test
IEC 61000-4-5 Surge immunity test
IEC 61000-4-6 Immunity to conducted disturbances, induced by radio frequency
fields
IEC 61000-4-8 Power frequency magnetic field immunity test
IEC 61000-4-11 Voltage dips, short interruptions and voltage variations
immunity tests
|
|
Dimensions and Weights |
| Height |
4RU - Rack-based system: 17.45 cm (6.87 in.)
|
| Width |
44.5 cm (17.48 in.) |
| Depth |
64.4 cm (25.4 in.) |
| Weight |
Minimum 31 kg (70 lb.)
Maximum 37.2 kg (82 lb.) |
|
Rack Mounting |
| Fits into a standard 19-inch-wide rack mount kit that complies
with EIA standard |
