This section provides the most common repair procedures for the 
  Netra 20, which are included in the following manual:
   
    | Component | Tips | 
   
    | CPU Module | 
        Guidelines for understanding and diagnosing UltraSPARC III Level 2 
          (L2) SRAM Cache Memory Errors (FIN I0887-1). | 
   
    | Disk Drive (Hot Swap) | 
        
           Improved firmware for Seagate 10K.6 disk drives will reduce the incidence of unexpected outages due to a spindle motor issue (I1136-1 ).Seagate ST336605FC 36GB and ST373405FC 73G drives could be susceptible 
          to label corruption (FIN I0816-1).Recovering from a failed FCAL boot disk (Problem article 1008580.1). | 
   
    | Disk Drive (Unmirrored Root Disk) | 
        
           Improved firmware for Seagate 10K.6 disk drives will reduce the incidence of unexpected outages due to a spindle motor issue (I1136-1 ).Seagate ST336605FC 36GB and ST373405FC 73G drives could be susceptible 
          to label corruption (FIN I0816-1).Recovering from a failed FCAL boot disk (Problem article 1008580.1).Seagate Cheetah 7 146GB FC-AL and 73 GB FC-AL disk drives
          may experience higher than expected failure rates due to
          spindle motor failure (FCO A0256-1).
         | 
   
    | Graphics Card | 
        XVR-500 Graphics Accelerator card does not function properly in Netra 
          20 servers (FIN I0900-1). | 
   
    | Memory | 
        Best Practices Guide for Memory Errors for diagnosing UltraSPARC III 
          memory errors now available (FIN I1018-1).Diagnosing Main Memory errors versus L2SRAM errors on UltraSPARC III 
          and UltraSPARC III Cu systems (FIN I0954-1).A sub-population of DIMMs that shipped between 2001 and 2002
          on the below platforms are showing significantly lower 
          reliability than expected (FCO A0253-1).Systems containing 256MB Samsung B-die DIMMs, having a module date 
          code between 0115 and 0127 (built between weeks 15 and 27 of 2001), 
          may experience Uncorrectable Memory Errors (UE). This can lead to System 
          Panics (FCO A0223-1). | 
   
    | PCI Card | 
        UltraSPARC III systems may panic due to a conflict between the Schizo 
          2.4 ASIC and the GigaSwift Ethernet PCI Card (FIN I0874-1). 
         | 
   
    | System Board | 
         UltraSPARC III and III+ based platforms could be susceptible to UCC 
          errors that may cause system panics (FIN I0856-1).
 |