| FAB
|
Implementation
|
Synopsis
|
Last Modified Date
|
| A0208-3 |
U
|
440MHz and 450MHz UltraSPARC II Modules in Ultra 60/80, Enterprise 220R/420R and Netra t platforms may experience Red State Exception, Send Mondo Timeout and hard hangs |
Mar 29 2004
|
| A0200-1 |
M
|
SunBlade 1000/2000 and Ultra 60/80 systems may exhibit a blank screen upon boot up with an XVR-1000 Graphics Accelerator installed. |
Jul 10 2002
|
| A0189-1 |
U
|
Ultra 60/80 and SunBlade 100/1000 systems with Expert3D-Lite cards and certain 21-inch monitors will have to either add or replace the monitor adaptor. |
Feb 22 2002
|
| A0186-1 |
U
|
SunPCi II and SunPCi IIpro cards may not respond after rapid/successive power cycling. |
Dec 03 2001
|
| A0182-2 |
U
|
Systems with 18.2GB and 36GB IBM disk drives may experience higher than expected failure rate. |
Feb 07 2005
|
| A0164-1 |
C
|
Systems with FC100/P cards (QL2100 PCI FC-AL HBA) having Molex optical transceivers, may cause increasing numbers of loop errors, excessive LIPs, and SCSI parity errors as they age. |
May 12 2000
|
| I0896-1 |
R
|
E420R Best Practices Troubleshooting Guide now available. |
2002-11-22
|
| I0689-1 |
R
|
To torque correctly on a specific Sun Products, refer to the Torque tool matrix for correct Torque Bit Type/Size and Torque Setting |
2002-09-26
|
| I0665-1 |
R
|
PCI Bus configurations on Ultra 80 system based boards |
2001-04-19
|
| I0642-1 |
R
|
DC-DC Converter module |
2001-03-16
|
| I0618-1 |
R
|
A screen resolution of 1024x768x75 for Creator (FFB) and Elite (AFB) Frame Buffers with any monitors is set incorrectly by the Open Boot PROM. |
2000-10-20
|
| I0607-1 |
R
|
Isolating problems on the Ultra 80 and E420R, Netra T 1400 and Netra T 1405 based systems |
2002-09-12
|
| I0570-3 |
R
|
Provide instructions and guidelines to CORRECTLY identify Ecache panic fault diagnosis. |
2000-07-07
|
| I0537-2 |
R
|
Memory Riser Card Torque Procedure for Correcting System Panics |
2002-05-30
|
